How to segment a small office LAN with VLANs on a Catalyst 9300?

Дата публикации: 05-10-2026 17:31:51

Hi everyone. I manage a small office network built around a single Catalyst 9300 switch, and I want to segment traffic into separate VLANs for staff workstations, guest Wi-Fi, and printers. What is the recommended way to configure trunk ports toward the access points and the router for inter-VLAN routing? Should I use a router-on-a-stick setup, or is it better to configure SVIs directly on the switch for routing between VLANs? I am also wondering how many VLANs are practical on this platform before management becomes a headache. Any guidance on best practices for naming and documenting VLANs would be appreciated.

Схожие новости

#	Наименование новости	Тональность	Информативность	Дата публикации
1	Cisco 9200L redundant power supply with different AC source	0	9.79	05-10-2026
2	CCNA Final Lab Challenge + Solution	0	7.78	05-10-2026
3	IOS firmware for Catalyst 2060c does not load entirely after upgrade	0	6.96	06-10-2026
4	SMF - GLC-LH-SMD useful with C9300-NM-8X	0	11.11	05-10-2026
5	Adding vlan to synergy network set without causing network disruption	0	11.52	02-10-2026
6	IR1835 SDWAN Controller Mode	0	8.33	06-10-2026
7	SSH Stale idle sessions	0	10.29	05-10-2026
8	Playing with teams, screens, and overall appearance	0	9.22	05-10-2026
9	Issues with fiber channel multipathing on HPE ProLiant DL385?	0	8.78	27-09-2026
10	GRE Tunnel Enters Recursive Routing State When OSPF Is Enabled	0	13.78	05-10-2026

Классификация: . Схожих патентов: 0. Схожих новостей: 10. Тональность: 0. Информативность: 7.84. Источник: community.cisco.com.